Speaker and Amplifier Matching Without the Spec-Sheet Myths
Sensitivity, impedance minima and amplifier current explained with in-room measurements, including the cases where a bigger amplifier changes nothing at all.
Daniel Ortiz 3 min read
Recently edited
Every guide
Every system plan, guide, comparison and measurement, newest edit first. Dates, sources and method notes sit on each page.
10 articles
Two-Channel Hi-Fi: Building the Signal Chain in Order
How to spec a stereo chain from source to speakers: sensitivity, impedance dips, amplifier current, DAC output and seat geometry, with the failure case measured.
Maya Chen 3 min read
A 5.1.2 System Plan for a Small Living Room
A room-first plan for a 5.1.2 system under 20 m2: budget split, channel order, wiring runs, subwoofer placement and the measurements that decide each step.
Maya Chen 3 min read
Reading a Frequency Response Chart Without Being Fooled
Why a range without a tolerance means nothing, how smoothing hides resonances, and the four chart features we check before publishing any speaker verdict.
Daniel Ortiz 2 min read
Center Channel Dialogue Clarity: What Actually Changes
Measured effects of height, tilt and crossover on speech intelligibility, plus the placement error that costs 4 dB at 2 kHz in a typical living room.
Maya Chen 2 min read
Outdoor Speaker Buying Guide: Weather, Wiring, Cost
What IP ratings do and do not promise, why amplifier distance changes the wire gauge, and the three line items that usually double an outdoor audio budget.
Daniel Ortiz 2 min read
Dolby Atmos Height Channels, Explained With Angles
What a height channel actually is, why elevation angle matters more than speaker count, and the ceiling conditions that make up-firing modules fail.
Maya Chen 2 min read
Subwoofer Room Calibration: Three Measurable Checks
A repeatable 30-minute routine: find the modal peaks, set phase with a two-seat sweep, then verify the 40 to 80 Hz spread. No golden ears required.
Maya Chen 2 min read
Bookshelf vs Tower Speakers: Which Fills Your Room
The real difference is bass extension and usable output, not size. Here is the room-volume threshold, the measured SPL cost and the crossover point where it flips.
Daniel Ortiz 2 min read
Home Theater Speaker Placement: A Measured Setup Guide
A numbered placement protocol for a 5.1.2 room: listening triangle, center height, subwoofer crawl and elevation angles, with the tolerances that matter.
Maya Chen 3 min read